Laser Cutting Machine Bottom Hanging Slag Causes And Solutions

I. Causes

Laser cutting machine is a kind of high efficiency, accurate cutting equipment, but in the use of the bottom may appear to hang slag. Caused by the bottom of the laser cutting machine hanging slag is mainly due to the following reasons:

1. Inappropriate cutting parameters. Cutting speed is too slow, power settings are not correct and other factors will lead to the bottom of the hanging slag.
2. The equipment is not timely cleaned up. In the process of use, with the cutting process, the waste slag produced can not be removed in time, accumulated in the cutting mouth, and eventually formed the bottom hanging slag.
3. Lack of auxiliary devices. Laser cutting machine in the structure of the equipment itself there may be some defects, such as cutting mouth at the bottom of the layout is unreasonable, not set up suction and discharge devices.

II. The Solution

For the bottom of the laser cutting machine hanging slag problem, we can take the following solutions:

1. Adjust the cutting parameters. According to the specific circumstances, reasonably adjust the cutting speed, power and other parameters, so that the cutting process is more fluent, reduce the bottom of the slag hanging.
2. Regular cleaning equipment. In the process of using the laser cutting machine, you should regularly clean up the equipment, remove the waste residue in a timely manner to prevent the accumulation of the formation of the bottom of the hanging slag.
3. Use of auxiliary devices. If there are defects in the structure of the equipment itself, you can use auxiliary devices to improve, such as setting suction and discharge devices.
4. Adjust the cutting order. For some of the bottom hanging slag more serious material, you can adjust the cutting order in the cutting, priority cutting bottom, reduce slag generation.
5. Replace the cutting head parts. If the cutting head parts have been worn, it is necessary to replace them in a timely manner, otherwise it will affect the cutting effect, resulting in the bottom slag.

In summary, the reasons for hanging slag at the bottom of the laser cutting machine is not complicated, mainly due to inappropriate cutting parameters, equipment is not timely cleaned up, the lack of auxiliary devices and other issues. The solution is also relatively simple, only need to adjust for the specific situation. For the use of laser cutting machine, do a good job of equipment maintenance and adjustment work, you can better play its efficient and accurate cutting function, reduce the occurrence of bottom hanging slag.

METMAC specializes in providing laser cutting machine accessories, laser focus mirror, cutting head, cutting nozzle, laser protection sheet, etc. Welcome to consult and exchange.